air conditioning technician crouched next to cooling unit after fixing it

PreciseAC Repair in WellingtonDiagnosed Properly

Half the systems we are called to did not need the part the last company quoted. We measure the refrigerant circuit, the electrical side and the airflow before anyone recommends anything — then you choose from real options.

Arrange a Diagnostic Call (561) 594-4792

Licensed Contractor

Labour Warranty

Arrange a Diagnostic Visit

Send the details and a technician will ring you back.

12,000

Systems Serviced

Since 2006

Trading Locally

96%

First-Visit Fixes

7 Days

Booking Available

Work We Take On

Single breakdowns through to full changeouts and ongoing contracts, for houses, barns and business premises alike.

Full System Diagnosis

The same measurement sequence on every call, however obvious the fault looks, checked against the data for your equipment rather than a rule of thumb.

What gets measured

Emergency Call-Outs

Seven days a week including evenings, with the rate quoted before anybody is dispatched. Ring first — a fair number of these end without a visit.

Can it wait until morning

Changeout & Upgrades

Sized from a load calculation, matched as a pair, permitted, inspected and commissioned — with every reading written down and handed to you afterwards.

Repair or replace

Recharge & Pressure Testing

Nothing in a sealed circuit gets used up. If the charge is down, there is a hole, and a nitrogen standing test finds it instead of guessing at it.

Why it keeps going low

Short Cycling & Compressor

Almost all compressor wear happens at start-up, so a system cycling six times an hour is ageing itself fast. Usually the cause is cheap to fix.

Counting the cycles

Noisy Air Conditioner

A screech, a grind and a rattle are three different failures. Which one you have decides whether to book a visit or switch the system off now.

What each noise means

Humidity Control

Seventy-three degrees and still clammy is rarely a broken air conditioner. It is usually one too large to run long enough to dry the house out.

Cold but not comfortable

Maintenance Plans

One reading tells you little; the same reading three years running tells you when a part will fail. Logged visits, and the record your warranty asks for.

Why tracking beats checking

What Sets Our Diagnostics Apart

Anyone can swap a capacitor. The difference shows up six weeks later, when the same fault returns because nothing addressed why the part died. We spend the extra twenty minutes finding that, and it is why so much of our work comes by referral.

Licensed Florida mechanical contractor, insured for residential and commercial work

Appointment windows that include evenings, so nobody burns a vacation day waiting

Diagnostic findings shown on the meter and explained before you are asked to decide

Repairs and installs on Carrier, Trane, Rheem, Lennox, Bryant, Daikin and Goodman equipment

Labour warranty in writing alongside the manufacturer coverage on parts

A Palm Beach County crew that services the same neighbourhoods week after week

Request an Appointment

From Call to Repair

Step 1: Tell Us the Symptom

A two-minute phone conversation usually narrows it down before dispatch. We book a window that suits you, including after work.

Step 2: Measure, Then Diagnose

Readings across the refrigerant circuit, the electrical side and the airflow path. We are looking for the cause, not just the broken part.

Step 3: Options, Then Repair

Where there is a cheaper way and a longer-lasting way, you hear both, with prices, before anyone picks up a tool.

refrigeration manifold gauge set connected to the service ports of a condenser

The Diagnosis Is the Product

Pressures on both sides, converted to saturation temperatures, then superheat and subcooling worked out and checked against the data plate for your particular equipment. Not against a rule of thumb, because a figure that is healthy on one system is a fault on another.

Only after that does anybody mention a part or a price. It takes longer than swapping the component that usually fails, and it is the reason the thing we replace is the thing that was actually broken.

Faults We Are Called Out To

Every one of these has several possible causes. Which is precisely why measuring beats guessing.

Cool Air, But Never Cold

Undercharge and airflow restriction

Certain Rooms Never Cool

Return sizing and duct balance

Blank or Dead Thermostat

Transformer, wiring, safety switches

Damp, Musty, Sticky Air

Humidity control and run-time

Outdoor Unit Freezing Over

Airflow, charge and coil condition

Breaker Keeps Tripping

Compressor draw and electrical fault

Rattle or Hum From the Handler

Motor mounts, blower wheel, relays

Bills Climbing Every Season

Performance testing and duct loss

The Measurement Almost Nobody Takes

A manometer across the air handler gives one number, and that number says whether the blower is fighting a restriction. Where the restriction sits then tells you whether to look at the filter, the coil, the ductwork or the motor.

It takes a few minutes and it removes essentially all of the guessing from a weak-airflow complaint. It is also the step that gets left out most often, which is why so many people are sold refrigerant for an airflow problem.